Cerkamed Rubberdam Likit - SKT: 09/2022 Outlet..!

Light-cured rubber-dam liquid

Light-cured RUBBER-DAM liquid is dedicated for:

• gingiva protection during dental treatments: whitening, etching, microabrasion, sandblasting etc.
  • sealing rubberdam.

    SKT: 09/2022 

    
    

    NEW QUALITY OF WORK

    PERFECT PROTECTION  of soft tissues

    WIDE RANGE OF USE

     

    Content:

    urethane resins, inorganic fillers

    Packaging:

    - Syringe containing 1.2 ml of the preparation + disposable applicators
    
    

     

    Method of use:

    For gingiva protection during dental treatments:
    Clean and dry gingiva. With the use of appropriate instruments (e.g. buccal and labial retractor) immobilize lips and a tongue in order to avoid contact with the liquid. Remove the syringe lock and install the included disposable applicator. Apply RUBBER-DAM LIQUID along the application area 4-6 mm wide and approximately 1.5-2 mm thick, at the same time overseeing the amount of the preparation being applied (Pic.1). If possible, squeeze RUBBER-DAM LIQUID through interdental space. Cure the preparation for 15 seconds using polymerization lamp (Pic.2). Conduct the curing process evenly in a scanning motion. Then, proceed the dental treatment. After the treatment is completed, lift off polymerized RUBBER-DAM LIQUID using the instrument on the either side and remove.

     

    

     

    In order to seal rubber dam:
    Isolate the working area (tooth, teeth, alveolus) using RUBBER-DAM. In order to seal rubber dam, apply the layer of the liquid on the edge of the gingiva and the rubber dam (Pic.3, Pic.5). Cure the preparation for 15 seconds using a polymerization lamp. Conduct the curing process evenly in a scanning motion (Pic.4, Pic.6). Then, proceed the dental treatment. After the treatment is completed, lift off polymerized RUBBER-DAM LIQUID using the instrument on either side and remove.

     

    without clamps

    

     

    with clamps

    

    Immediately after use withdraw the syringe plunger and place the original cap on the container to avoid polymerization of the product in the syringe. The product is intended for reusing, while the applicator is designed for disposable use. Reusing the applicator may cause the hazard of secondary infection.